Controles Avanzados

HotCues

Press the CUES mode button (12) to set the top 3 numbered buttons (13) in HotCue mode (selection per side/deck).

Each one of the 3 buttons (13) assigns a Hot Cue Point or jumps to that Hot Cue Point.
When a Hot Cue Button is unlit, you can assign a Hot Cue Point by pressing it at the desired point in your track.

Hold the CUES mode button (12) down and then press a button to delete its assigned Hot Cue Point.
Hold the CUES mode button (12) down and then use the Parameter Encoders (11) to navigate through the track (fast seek)

Sampler

Press the SAMPLE mode button (12) to set the top 3 numbered buttons (13) in Sampler mode (selection per side/deck).

Each one of the 3 buttons (13) triggers a sample from the selected Sampler Bank of VirtualDJ.
If a bank has less than 4 samples, both sides of the unit will control the same samples. If a bank has more than 3 samples, the left side of the unit will control samples 1 to 3 and the right side samples 4 to 6.

Hold the SAMPLE mode button down and then …

• Press a button to stop the playing sample (useful if the Unmute or Stutter trigger mode is selected)
  
• Use the left Parameter Encoder (11) to select and load a different Sampler bank.
  
• Use the right Parameter Encoder (11) to adjust the Master Volume of the Sampler .

Effects

Press the FX mode button (12) to set the top 3 numbered buttons (13) in Effects mode (selection per side/deck).

Each one of the 3 buttons triggers the selected effect of Slot 1 to 3. The selected effects from all 3 slots can be triggered at the same time (chain effect).

Hold the FX mode button down and then …

• Press any of the 3 buttons (13) to select the next effect for the relative Effect slot.
  
• Use the Jogwheel (4) to adjust the 1st Parameter of all 3 Effects slots simultaneously
  
• Use the Parameter Encoder (11) to adjust the High-Low Pass Filter of the deck and push the same Encoder to reset the Filter to its zero value (turn off).

Loops

When both PARAMETER MODE buttons (10) are unlit, use the Parameter Encoders (11) to select the size of the Loop in beats for the left and right decks. Push the same Encoder to trigger the loop.

While a loop is enabled, use the Jogwheel (4) to move/shift the Loop forward or backwards through the track. The Jog Illumination will indicate the Loop progress bar. The Jogwheel will return to the Scratch /Bend status automatically when the loop is turned off.

Browser

Press the left PARAMETER MODE button (10) to set the Parameter Encoders (11) to Browser mode. The Led of the left button will be turned on as an indication.

While in Browser mode…

• Use the left Parameter Encoder (11) to scroll through folders.
  
• Use the right Parameter Encoder (11) to scroll through tracks.
  
• Push the Parameter Encoders to load the selected track to left or right deck. Hold down the Parameter Encoders for more than 1 sec to unload the same deck.

Mixer

Press the right PARAMETER MODE button (10) to set the Parameter Encoders (11) to Mixer mode. The Led of the right button will be turned on as an indication.

While in Mixer mode…

• Use the Parameter Encoders (11) to adjust the Gain of the left and right decks.
  
• Push the Parameter Encoders (11) to send the left or/and right deck to the Prelisten Output Channel (Headphones is required to be defined in Audio Setup)