Hardware Manuals
Efectos
Rane Seventy-Two offers you the ability to combine Hardware Effects (Flex FX) with Software Effects at the same time.
You can activate up to four Effects at once per deck. Three of them are software (provided by VirtualDJ) and one of them is hardware (provided by Rane Seventy-Two firmware).
For this reason the screen of Rane Seventy-Two offers four effect slots per deck numbered as 20, 21, 22 and 23 on the picture above.
The way effects work with Rane Seventy-Two differs from the way effects work with most other controllers.
You must "arm" an effect first before you are able to activate / apply it on a deck.
For this, you must use the buttons marked as 16, 17, 18 and 19 to arm the effects you wish to use, and then activate them by using the EFFECTS lever (marked as 27)
When you use the EFFECT lever, all armed effects are activated at once (chained effects).
KEY
ACTION
Due to firmware limitations, for the effects to operate properly with VirtualDJ, left side of the screen must be assigned on deck 1 and right side on deck 2.
- Click on one of the FX slots (20, 21, 22 or 23).
A white arrow will show up on the slot's box. This indicates that the slot is selected. - Turn the PARAMETER knob clockwise to increase the strength of the effect. Turn the PARAMETER knob counter clockwise to decrease the strength of the effect.
- Push the PARAMETER knob down.
The FX ARM button of the selected slot should start blinking. - Turn the PARAMETER knob to select a new effect for the slot.
- Push the PARAMTER knob once more. The selection has been completed and the slot will stop blinking.
When the slot is armed the led of the button will turn on with full brightness.
When the slot is armed the led of the button will turn on with full brightness.
When the slot is armed the led of the button will turn on with full brightness.
When the slot is armed the led of the button will turn on with full brightness.
Click the box with your finger to select slot 1 as the "working" slot for the PARAMETERS knob (a white arrow will appear on top side of the box)
Click the box with your finger to select slot 2 as the "working" slot for the PARAMETERS knob (a white arrow will appear on top side of the box)
Click the box with your finger to select slot 3 as the "working" slot for the PARAMETERS knob (a white arrow will appear on top side of the box)
Click the box with your finger to select slot 4 as the "working" slot for the PARAMETERS knob (a white arrow will appear on top side of the box)
Please note that the effects on this slot are provided by Rane Seventy-Two firmware (hardware effects)
Click on one value and use the PARAMETERS knob to adjust it.
Please note that effect beats timing is not available for all software effects
Touch the screen at any place inside the parameters box to apply momentarily (while pressed) the selected effects. Once you lift your finger, the effects will stop from being applied.
You can reverse these levers so that upper position is momentarily and down position is permanent if you wish. For further details please advise the unit's user guide.
By default the effects on Rane Seventy-Two are applied as post-fader effects. This means that they are applied after the volume fader setting. This mode allows effects trailing to be heard even after turning channels volume to zero. However for this reason you won't be able to pre-listen the effects on your headphones. If you wish to change this behavior you can change the fxProsessing setting in VirtualDJ options and set it to pre-fader.